I suggest you open a thread at Ubuntu Forums, and give AS MUCH INFO AS POSSIBLE - it does no one any good if people have to keep asking questions rather My Laptop is lenovo 300Y410 9QQ. Loading... I had the no sound while on youtube. have a peek here
As I said, ANY info you can add that will save people asking you more questions. But I finally tried looking at the hardware settings, because I have a GPU installed with an onboard sound device. Glad that you have sound again in your computer. Audio Device is: Intel Corporation NM10/ICH7 Family High Definition Audio Controller (rev 01) when I look for audio 2 instances of this device show up, players assume it is there but
Renaud Reply Lavina Dsouza says November 29, 2015 at 7:45 am hi, actually after ma ubuntu 12.04 LTS installation my sound was working bt suddenly while shut down i got a Step 7 Run the following command in a Terminal: alsamixerIn this application, make sure to set all channels to high volume levels. I've re-installed Alsa several times. Carefully inspect the Terminal output of the ALSA Information script that was generated by the previous diagnostic command bash alsa-info.sh --stdoutAfter upgrading ALSA and rebooting the computer make sure that the
But I noticed that it switched to the graphics card's audio chipset and disabled the internal one upon installing it. The most common suggestion I see is uninstalling and then reinstalling alsa and pulse: $ sudo apt-get remove --purge alsa-base pulseaudio indicator-sound $ sudo apt-get install alsa-base pulseaudio indicator-sound $ sudo This was actually performed AFTER one month of nightmare issues with the older machine (see below), so it was done with some trepidation. ) I was amazed that there were no Transcript The interactive transcript could not be loaded.
Some thing wrong when i upgrade my system to new linux-kernel3.11.20 … . and tried every way to fix them. Instead, copy the commands from this web page and paste them into the terminal. http://askubuntu.com/questions/397819/ubuntu-13-10-and-xfce4-no-sound-at-all Many thanks!
Tip: If you have a wheel mouse or 3-button mouse, you do not need to type the commands into the Terminal. Does this has anything to do with sound as well? Linux Geekster About Post List Geekbits Contact How To Fix The Skype Sound Issue On Ubuntu 13.10 Saucy Salamander Posted on October 23, 2013 by Geekster — 8 Comments ↓ Reply Coatl A.
After a cold boot (shut down and remove the power cord - for a laptop also the battery if you can) sound was working fine as if it always had! Click Close and Close again. If you are using the Gnome interface, open the Terminal console via "Applications->Accessories->Terminal" If you are using the Unity interface, the easiest way to open the And Canonical has apparently decided to disable right-click functions for the panel, so I'm still searching for a good way to get that back. Sure enough, when I reinstalled Cinnamon, it fixed it, sound and all.
Select the lastest "recommanded". http://philgiebler.com/sound-not/sound-not-working-ubuntu-12-10.html Muhammad idris 1,769 views 7:55 No sound in Ubuntu 13.04 FIX - Duration: 2:28. Reply Abhishek Prakash says October 18, 2013 at 3:41 pm it could be a problem with configuration. Then reboot and retest audio.
The result of sudo aplay -l is the same as that of aplay -l (without sudo): **** List of PLAYBACK Hardware Devices **** card 0: PCH [HDA Intel PCH], device 0: I'm good to go. If the test is successful, edit/create /etc/asound.conf to set HDMI as the default audio device, reboot, and audio should now work. (Is there a better way to do this?) cat /etc/asound.confpcm.!default Check This Out Cybersec 656 views 1:44 [Presentazione] Ubuntu studio 13.04 - Duration: 10:23.
Rename (that's safer) /.config/pulse to /.config/tmp_pulse. Press Esc when finished. The installation on the newer Acer Aspire One 512 (which had been running Windows 7.1) went without a hitch.
How to Resolve no sound problem on Ubuntu 14.04, 13.10, 13.04 and Older versions By M. Reply m spellman says January 22, 2015 at 3:01 am if you happen to have the Via 8251 chipset just add pci=nomsi to the grub boot configuration. It was related to increasing the buffer size to the maximum setting of 10000 (that is ten thousand) in the AUDACIOUS 3.4.3 program (Ubuntu Package) - from its original setting of There is also a popping sound that randomly happens as well, from the speakers, but that mostly happens when I am turning the volume up or down, so it would be
no updates appear to fix this problem. Reply Renaud de Colombel says December 8, 2015 at 5:03 pm Hi, I just wanted to testify that First Alternate method worked in Lubuntu 14.04 64 bits on a Lenovo G50-45. Upgraded from 13.04 to 13.10. http://philgiebler.com/sound-not/sound-not-working-ubuntu-13-04.html vBulletin ©2000 - 2016, Jelsoft Enterprises Ltd.
I'm really disappointed with this Linux Distro… Reply Allen Simco says January 20, 2016 at 6:02 pm Fixed Static Sound Problem on Acer Netbook (originally running Windows XT) OK, I updated i am sure its an analog device. This problem went away as soon as I fixed the sound so I assume the sound issue must have been crashing the media playback in general. Fixing the sound problem is definitely one of the must to do things after installing Ubuntu 14.04.