Loading...

Home > Sprinkler System > Sprinkler Station Not Working

Sprinkler Station Not Working

Contents

Top rwwoods Posts: 1312 Joined: Thu Jun 07, 2007 7:54 pm Location: The Villages, Florida Quote Postby rwwoods » Thu May 05, 2011 7:05 pm My friend's system stoped because of WatermasterIrr 38.579 görüntüleme 5:06 Wiring an Irrigation Solenoid Valve - Süre: 8:12. Aloha Like Bookmark August 19, 2010 at 7:34PM Thank you for reporting this comment. Thanks again for the suggestions! his comment is here

Leak in connection between 1/2 1 Questions regarding fert injection using a Mazzei injector design 1 Last call for Florida Water Star test date - Gainesville, FL New Lawn and Sprinkler Be sure to read any manufacturers literature available regarding your system.This video is published in good faith for entertainment purposes only, and it is not a comprehensive guide. BigD53 is the guy watering down the dirt around the base paths before the game and at the 7th inning stretch. One long stride is 3 feet.

Sprinkler System Not Working In All Zones

Turn the valves to their open positions as shown. Make the wire connections with the controller turned off. I'm with you BigD53; it's all good.

Top earlyout Posts: 1228 Joined: Tue Feb 20, 2007 5:24 pm Quote Postby earlyout » Fri May 06, 2011 10:26 am It was working okay. Like Bookmark March 26, 2016 at 9:10PM Thank you for reporting this comment. Make final adjustments with the water running. Sprinkler System Won't Turn On I similarly hear water at the box for zones 1 and 2 when I attempt to run them from the control box in the garage, as well, but nothing happens at

New ones start at $175 and can cost upward of $400. Sprinkler System Troubleshooting Solenoid If the system is plugged into a GFCI receptacle, press the GFCI reset button. Once you verify that the sprinkler system is getting water pressure, you should then find the valve that controls the particular zone in question and manually turn it on (its in find more info Locating the valve to begin with can also be problematic, which, again, would call for specialized tools to locate.Need help or advise?

Look for a rounded type fitting with a shiny black cylinder on top. None Of My Sprinkler Zones Are Working Refer to your owner's manual to see whether the voltage reading falls within the required range (usually 24 to 28 volts). GL Aloha Like Bookmark August 28, 2010 at 12:36PM Thank you for reporting this comment. Just open the cleanout on the manifold and see if water comes out.

Sprinkler System Troubleshooting Solenoid

Walk around your house/garage looking for a little gizmo with a wire attached to it. http://sprinklertalk.com/wbb/index.php?page=Thread&threadID=3766 I've been dragging a hose around for the past 56 years. Sprinkler System Not Working In All Zones The controller display faded away and turned completely off every time I tried to turn any station in auto, manual or test mode. Sprinkler Zone Won't Turn On Like Bookmark August 20, 2010 at 12:37PM Thank you for reporting this comment.

Pull on the each wire lightly to make sure it is snugly screwed in with the wire that goes to the controller. this content you can also take a test light to the clock, to make sure your timer is not the problem, by touching the same conections.hope that helps a bit 04-16-08,09:26 PM #4 There is no water going to the sprinkers. Every time the display would shut down. Sprinkler System Zone Won't Turn Off

Let us know. "The wants of mortals are containers that can never be filled." (Socrates) Top sscritic Posts: 21858 Joined: Thu Sep 06, 2007 8:36 am Quote Postby sscritic » Fri Photo 2: Reconnect the wires Connect the two wires on the new solenoid to the common wire and a field wire, using waterproof connectors. I suddenly have a problem with the system not working. weblink Did you open the valves by using a screwdriver in your hand to turn the release screw on the physical valve?

Note: a lot of anti-siphon valves are not properly installed.  Even sprinkler installation companies don't use the care they should to insure correct installation, and a incorrect installation may be the Sprinkler System Troubleshooting No Water Clean & Repair a Valve: Most people try to repair the valve rather than replace it.  I really think a repair is often easier at this stage.  If you do proceed what am i doing wrong, and what can i do right?

He thinks I need to check the plug, adapter and change the battery.

Photo 3: Adjust the spray Adjust the watering range of the sprinkler head before installing it. Be very careful around the controller terminal even though this is a low voltage system it has a 120v voltage side. Check Fuse and Transformer 1If the voltage reading on the multimeter is 0, check the fuse. Sprinkler System Troubleshooting Low Pressure Undo lehua49 Holia, Are you willing to try testing the plug yourself?

The position it is in now (parallel to the pipe) is ON and 90 degrees to the pipe is OFF. Re rain sensor, they are usually attached to a rain gutter. Water will slowly seep out of the valve opening, even with the water turned off. check over here Home Guides Home Home Improvement Home Maintenance by Demand Media Home Guides » Home » Home Improvement » Home Maintenance » How to Fix One Zone of My Lawn Sprinkler System

Orbit Irrigation 442.402 görüntüleme 3:29 How to replace a sprinkler valve. - Süre: 8:01. If it's working, plug the transformer back in, turn the system off and test the transformer for voltage. So I just changed the current sprinkler value that was not working thinking it was the solenoid or value, but after replacing it, it still does not work. I undid, re-stripped and re-attached all the wires This had no results.

Let us know what you do and find. Was it installed by a professional? Not an easy thing to do and people not familiar with doing this are prone to not putting all the parts back in especially the small o-ring. Whenever working with electrical power, be careful for the safety of yourself and your family.

When I say manual, I don't mean the opposite of automatic, I mean use of the hand. None of the 6 zone valves operate and it is unlikely they all failed at the same time. Your watering system is divided into a series of zones. Of course, then you need instructions on how to use your phone's video first and how to stream it to someone on the internet.

I'll try to put a link to my pictures of the controller and the valve. Remember Me Log In Join us Cancel Don't have an account yet? The valves open, sending water through the underground water line, which causes the sprinkler heads to pop up and spray. It might be over tight and not working.

The internal bleed on the PGV mechanically lifts the solenoid piston off of the upper chamber exhaust port allowing the water to be released into the downstream pipe. Each zone has an electrically activated valve that controls the heads for a designated area. The controller sends a low voltage signal to the solenoid again when it is time to shut off the valve. If there is no knob on top, there will be a screw just to the side, as on the toro.

Thank you so much for your help!

© Copyright 2017 philgiebler.com. All rights reserved.