Home > Sprinkler System > Sprinkler System One Station Not Working

Sprinkler System One Station Not Working


Attach your valve actuator to the 2 wires at the controller end, just like you did to the solenoid wires.  The valve should come on.  If it doesn't open, or only Generally, if you have a zone that's not turning on, you have an electrical problem. I Googled it, but they look so different, so I'm not sure what I need to buy. Like Bookmark August 20, 2010 at 12:37PM Thank you for reporting this comment. his comment is here

I'll try to check the wires on weekend. Insert the wires on the new transformer through the designated opening in the controller. What's the name of your controller? Privacy Policy Back to Top × Choose Your Language English - USA English - Metric Español Italiano Français Português Deutsch Türkçe Polski Русский العربية 中国/中华 Skip to main content  English -

Sprinkler System Not Working In All Zones

Reader's Digest Taste of Home Recipes © 2016 HOME SERVICE PUBLICATIONS, INC. The electrical lines are low voltage, so they're not hazardous. Weird. I'm a first-time homeowner, and therefore new to the world of sprinklers, and need your help: I have a 6 zone, residential sprinkler system at my home.

Adjust the heads before installing them, then fine-tune them once they're in place with the sprinkler running. iScaper1 93,885 views 5:31 Sprinkler Valve Troubleshooting - Duration: 2:05. If the valve will not turn on manually, check the water supply to the valve. Sprinkler System Won't Turn On Thank you so much for your help!

At first, I suspected the controller because both of the valves' solenoids operated perfectly when the controller was placed on "MANUAL" mode, indicating current was flowing through each circuit and to Sprinkler System Troubleshooting Solenoid Like Bookmark May 8, 2015 at 9:56AM Thank you for reporting this comment. You think it could be close to the house, under the bushes (landscaping), covered with mulch? http://www.familyhandyman.com/landscaping/fixing-sprinkler-systems/view-all Not sure if relevant, but we (gardener) did change front yard sprinkler stations prior to the backyard issue started.

Like Bookmark February 13, 2015 at 8:14AM Thank you for reporting this comment. Sprinkler System Troubleshooting Low Pressure My controller is Rain Bird E-6c. Then check for leaks in the water line. Adjust the head to set the watering rotation anywhere from 40 degrees to 360 degrees counterclockwise from the starting point.

Sprinkler System Troubleshooting Solenoid

Your cache administrator is webmaster. http://www.hunterindustries.com/en-metric/support/why-my-controller-not-starting-watering-cycle Upon attempting the same thing again the next day, zone 1 was again totally inactive. Sprinkler System Not Working In All Zones If the ohms number is lower than the recommendation in the owner’s manual, the solenoid switch that activates the sprinklers is defective. 2To replace the solenoid, turn the controller off and Sprinkler System Zone Won't Turn Off Some states require rain sensors on all new systems. (Your rain sensor is bad if the system runs when the ground is already wet.) If the system doesn't run in the

Place a clamp on the second pipe end, expand the coupling while inserting the nipple into the pipe, then tighten the clamp. this content Aloha Like Bookmark March 28, 2012 at 6:12PM Thank you for reporting this comment. Bury the wire at least 8 in. I assume it's the valve or blockage of some king..any help? Sprinkler Zone Won't Turn On

Undo holia123 The photo #4 that I posted earlier is the box that says on top "irrigation control system". Just open the cleanout on the manifold and see if water comes out. cut the two vave wires, restrip and join again. http://philgiebler.com/sprinkler-system/sprinkler-station-not-working.html when zones don't operate, it can only be a few things.

When you are done watering zone 4 turn the solenoid clockwise(do not over tighten) until the zone stops watering. None Of My Sprinkler Zones Are Working Things You Will Need Multimeter Phillips screwdriver Owner's manual Tip It does not matter which lead you touch to which terminal when checking the voltage of the controller or transformer. I heard that it could be the problem and it also could be easily replaced.

Place a new solenoid in the valve and turn it until it's finger-tight.

I'll try to put a link to my pictures of the controller and the valve. Touch the leads to the common terminal and zone terminal. Step 4. Sprinkler System Troubleshooting No Water Step 3.

Working... Your watering system is divided into a series of zones. Caution: Before you start digging to access the underground water lines, electrical wires or spray heads, dial 811 to have your underground utility lines identified and marked.

Back to Top http://philgiebler.com/sprinkler-system/sprinkler-system-not-working.html If the voltage falls below the manufacturer's range, replace the transformer.

All you have to do is make room for any freeze-up to expand. So, in other words, I turn another little black cylinder (a tiny one) in order to irrigate my back yard manually. How to Unclog a Drain Reader's Digest Taste of Home Recipes © 2016 HOME SERVICE PUBLICATIONS, INC. Your transformer may have gone out.

© Copyright 2017 philgiebler.com. All rights reserved.